Blog (Heading)
Reset drum (photoconductor) Dell
How to reset the photoconductor counter
| Read comments | Leave your comment |
Instructions
-
Resetting the Drum Page Counter
- 1
Shut off the printer.
- 2
Hold down the "Cancel" button while opening the front door. Then turn on the printer
- 3
Keep the Continue button held down until only the "Error LED" is on then release the button. Close the door.
- 4
The Continue button, Ready/Data, Toner Low, and Load Paper LEDs should all be lit up.
- 5
Press "Cancel" a few times to cycle through the LEDs until just the "Toner Low LED" is lit.
- 6
Press and hold the "Continue" button until the LEDs cycle through and release only when the LED stops at Toner Low.
- 7
Turn the printer off and back on.
- 1
| Read comments | Leave your comment |
Source of information: Service support, Dell & SCC & Uninet & Summit
Article Categories
Leave your comment